State-Refresh-Rate-Limit (Ipv6 Pim View); Static-Rp (Ipv6 Pim View) - HP 6125XLG Command Reference Manual

<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] state-refresh-interval 70
Related commands
ipv6 pim state-refresh-capable
•
state-refresh-hoplimit (IPv6 PIM view)
•

state-refresh-rate-limit (IPv6 PIM view)

•
state-refresh-rate-limit (IPv6 PIM view)
Use state-refresh-rate-limit to configure the time that the device waits before receiving a new state refresh
message.
Use undo state-refresh-rate-limit to restore the default.
Syntax
state-refresh-rate-limit time
undo state-refresh-rate-limit
Default
The device waits 30 seconds before it receives a new state refresh message.
Views
IPv6 PIM view
Predefined user roles
network-admin
Parameters
time: Specifies a time that the device waits before receiving a new refresh message, in the range of 1 to
65535 seconds.
Examples
# Configure the device to wait 45 seconds before it receives a new state refresh message.
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] state-refresh-rate-limit 45
Related commands
• ipv6 pim state-refresh-capable
state-refresh-hoplimit (IPv6 PIM view)
•
state-refresh-interval (IPv6 PIM view)
•

static-rp (IPv6 PIM view)

Use static-rp to configure a static RP.
Use undo static-rp to remove a static RP.
182