Ipv6 Neighbor Stale-Aging - HP 6125G Command Reference Manual

Layer 3 - ip services command reference
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

mac-address: Specifies the MAC address of the static neighbor entry (48 bits long, in the format of
H-H-H).
vlan-id: Specifies the VLAN ID of the static neighbor entry, in the range of 1 to 4094.
port-type port-number: Specifies a Layer 2 port of the static neighbor entry by its type and number .
interface interface-type interface-number: Specifies a Layer 3 interface of the static neighbor entry by its
type and number.
Description
Use ipv6 neighbor to configure a static neighbor entry.
Use undo ipv6 neighbor to remove a static neighbor entry.
You can use a Layer 3 VLAN interface or a Layer 2 port in the VLAN to configure a static neighbor entry.
If the first method is used, the neighbor entry is in the INCMP state. After the device obtains the
corresponding Layer 2 port information, the neighbor entry will go into the REACH state.
If the second method is used, the corresponding VLAN interface must exist and the port specified by
port-type port-number must belong to the VLAN specified by vlan-id. After the static neighbor entry
is configured, the device will relate the VLAN interface with the IPv6 address to identify the static
neighbor entry uniquely and the entry will be in the REACH state.
To remove a static neighbor entry, you only need to specify the corresponding VLAN interface and the
neighbor address.
Related commands: display ipv6 neighbors.
Examples
# Configure a static neighbor entry for Layer 2 port GigabitEthernet 1/0/1 of VLAN 100.
<Sysname> system-view
[Sysname] ipv6 neighbor 2000::1 fe-e0-89 100 GigabitEthernet 1/0/1

ipv6 neighbor stale-aging

Syntax
ipv6 neighbor stale-aging aging-time
undo ipv6 neighbor stale-aging
View
System view
Default level
2: System level
Parameters
aging-time: Age timer for ND entries in stale state, ranging from 1 to 24 hours.
Description
Use ipv6 neighbor stale-aging to set the age timer for ND entries in stale state.
Use undo ipv6 neighbor stale-aging to restore the default.
By default, the age timer for ND entries in stale state is four hours.
135

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents