Configuring A Static Rpf Peer; Configuring An Msdp Peer Connection; Configuration Prerequisites - HP 4800G Series Configuration Manual

To do...
Enter system view
Enter MSDP view
Create an MSDP peer
connection
If an interface of the router is shared by an MSDP peer and a BGP/MBGP peer at the same time, we
recommend that you use the IP address of the BGP/MBGP peer as the IP address of the for the MSDP
peer.

Configuring a Static RPF Peer

Configuring static RPF peers avoids RPF check of SA messages.
Follow these steps to configure a static RPF peer:
To do...
Enter system view
Enter MSDP view
Configure a static RPF peer
If only one MSDP peer is configured on a router, this MSDP will be registered as a static RPF peer.

Configuring an MSDP Peer Connection

Configuration Prerequisites

Before configuring MSDP peer connection, complete the following tasks:
Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
Configuring basic functions of MSDP
Before configuring an MSDP peer connection, prepare the following data:
Description information of MSDP peers
Name of an MSDP mesh group
MSDP peer connection retry interval
Use the command...
system-view
msdp
peer peer-address
connect-interface
interface-type interface-number
Use the command...
system-view
msdp
static-rpf-peer peer-address
[ rp-policy ip-prefix-name ]
1-9
Remarks
—
—
Required
No MSDP peer connection
created by default
Remarks
—
—
Required
No static RPF peer configured
by default