Basic Ce1 Interface Configuration Commands; Alarm - HP 6600 Command Reference Manual

Parameters
virtualbaudrate: Baud rate (in bps) to be set, which must be consistent with the one configured at the DCE
side. It can be 1,200, 2,400, 4,800, 9,600, 19,200, 38,400, 56,000, 57,600, 64,000, 72,000,
1 15,200, 128,000, 192,000, 256,000, 384,000, 512,000, 768,000, 1024,000, 2,048,000, or
4,096,000.
Usage guidelines
When working as DTE, the serial interface determines its baud rate through negotiation with the DCE
side. The virtualbaudrate command, however, allows you to configure DTE-side baudrate manually, but
the configured value must be the same as the one set at the DCE side.
Configure the baudrate command at DCE side and the virtualbaudrate command at DTE side (only
when the interface is operating in synchronous mode). Avoid configuring the two commands at the same
end of a link.
At DCE side, the display interface command displays the baud rate of the interface; whereas at the DTE
end, the command displays the virtual baud rate of the interface.
Examples
# Set the virtual baudrate of DTE interface Serial 1/0/0 to 19200 bps.
<Sysname> system-view
[Sysname] interface serial 1/0/0
[Sysname-Serial1/0/0] virtualbaudrate 19200
Related commands
baudrate
•
clock
•

Basic CE1 interface configuration commands

Alarm

Use alarm to enable RAI detection on the interface.
Use undo alarm to disable RAI detection on the interface.
Syntax
alarm detect rai
undo alarm detect rai
Default
RAI detection is enabled on an interface.
Views
CE1 interface view
Default command level
2: System level
Parameters
detect: Enables periodical detection on the interface.
87