Sub-Interface Rate-Statistic; Layer 2 Ethernet Interface And Subinterface Configuration Commands; Broadcast-Suppression - HP 6600 Command Reference Manual

sub-interface rate-statistic

Use sub-interface rate-statistic to enable rate statistics collection for the subinterfaces of an Ethernet
interface.
Use undo sub-interface rate-statistic to disable rate statistics collection for the subinterfaces of an
Ethernet interface.
Syntax
sub-interface rate-statistic
undo sub-interface rate-statistic
Default
The system does not collect rate statistics for Ethernet subinterfaces.
Views
Ethernet interface view
Default command level
2: System level
Usage guidelines
Use this function with caution, because it requires a large amount of system resources.
Examples
# Enable rate statistics collection on the subinterfaces of GigabitEthernet 4/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 4/0/1
[Sysname-GigabitEthernet4/0/1] sub-interface rate-statistic
Layer 2 Ethernet interface and subinterface
configuration commands
The commands in this section are supported on only SAP modules operating in bridge mode.

broadcast-suppression

Use broadcast-suppression to set the broadcast suppression threshold on an Ethernet interface, a
subinterface, or a group of Ethernet interfaces.
Use undo broadcast-suppression to restore the default broadcast suppression threshold.
Syntax
broadcast-suppression { ratio | pps max-pps | kbps max-kbps }
undo broadcast-suppression
Default
Ethernet interfaces do not suppress broadcast traffic.
30