WAN interface configuration commands
Common WAN interface configuration commands
bandwidth
Use bandwidth to set the intended bandwidth for the interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
Serial interface view, E1-F interface view, T1-F interface view, CE3 interface view, CT3 interface view,
CE1 interface view, CT1 interface view
Default command level
2: System level
Parameters
bandwidth-value: Intended bandwidth for the interface, ranging from 1 to 4,294,967,295 kbps.
Usage guidelines
You can obtain the intended bandwidth of an interface by querying the ifspeed value of the MIB node
with third-party software.
The intended bandwidth is used for bandwidth monitoring of the network management, but does not
affect the actual bandwidth of the interface.
Examples
# Set the intended bandwidth to 50 kbps for interface Serial 2/1/1.
<Sysname> system-view
[Sysname] interface serial 2/1/1
[Sysname-Serial2/1/1] bandwidth 50
default
Use default to restore the default settings for the interface.
Syntax
default
Views
Serial interface view, E1-F interface view, T1-F interface view, CE3 interface view, CT3 interface view,
CE1 interface view, CT1 interface view
69