Step
2.
Enter IGMP view.
3.
Enable the load splitting
function on the IGMP proxy.
Displaying and maintaining IGMP
CAUTION:
The reset igmp group command might cause multicast data transmission failures.
Execute display commands in any view and reset commands in user view.
Task
Display IGMP group information.
Display IGMP information.
Display multicast group
membership information
maintained by the IGMP proxy.
Display information about IGMP
proxy routing table.
Display IGMP SSM mappings.
Clear all the dynamic IGMP
group entries of the specified
IGMP group or all IGMP groups.
IGMP configuration examples
This section provides examples of configuring IGMP on routers.
Basic IGMP functions configuration examples
Network requirements
As shown in
VOD streams are sent to receiver hosts in multicast. Receiver hosts of different organizations form
•
stub networks N1 and N2. Host A and Host C are receiver hosts in N1 and N2, respectively.
Command
display igmp [ vpn-instance vpn-instance-name ]
group [ group-address | interface interface-type
interface-number ] [ static | verbose ]
display igmp[ vpn-instance vpn-instance-name ]
interface [ interface-type interface-number ]
[ proxy ] [ verbose ]
display igmp [ vpn-instance vpn-instance-name ]
proxy group [ group-address | interface
interface-type interface-number ] [ verbose ]
display igmp [ vpn-instance vpn-instance-name ]
proxy routing-table [ source-address [ mask
{ mask-length | mask } ] | group-address [ mask
{ mask-length | mask } ] ] * [ verbose ]
display igmp [ vpn-instance vpn-instance-name ]
ssm-mapping group-address
reset igmp [ vpn-instance vpn-instance-name ]
group { all | interface interface-type
interface-number { all | group-address [ mask
{ mask | mask-length } ] [ source-address [ mask
{ mask | mask-length } ] ] } }
Figure
26:
Command
igmp [ vpn-instance
vpn-instance-name ]
proxy multipath
68
Remarks
N/A
By default, the load splitting
function is disabled.
Remarks
N/A
N/A
N/A
N/A
N/A
This command
cannot remove static
IGMP group entries.