Display Controller Cpos E3 - HP 6600 Command Reference Manual

Field
Frame-format SDH, multiplex AU-4,
clock master, loopback not set
Tx: J0: 0x01
Rx: J0: 0x01
Regenerator section:
Multiplex section:
Higher order path(VC-4-1):
Lower order path
Alarm:
Error:
Cpos2/0/0 CE1 1 is up
Frame-format, clock, loopback
E1 framer(1-1-1-1)

display controller cpos e3

Use display controller cpos e3 to display the physical layer configuration of the specified E3 channel on
the specified CPOS interface.
Syntax
display controller cpos cpos-number e3 e3-number [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
cpos-number: CPOS interface number.
e3-number: Number of an E3 channel on the specified CPOS interface, in the range of 1 to 3.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
Description
Physical layer information of the CPOS interface.
In this sample output, the framing format is set to SDH, AU-4 path is
adopted, master clock (internal clock signal) is used, and loopback
is disabled.
Sent overhead bytes.
Received overhead bytes.
Alarm and error statistics about the regenerator section.
Alarm and error statistics about the multiplex section.
Alarm and error statistics of the E1 path. VC-4-1 represents the
second VC-4.
Alarm and error statistics of the lower order E1 path.
Alarm statistics.
Error statistics.
Current physical state of E1 channel 1 of CPOS 2/0/0.
Physical layer information of E1 channels.
In this sample output, the framing format is set to NO-CRC4, slave
clock mode is used, and loopback is disabled.
Indicates how the E1 channel is multiplexed. 1-1-1-1 represents in
order VC-4 number, TUG-3 number, TUG-2 number, and TU-12
number for an E1 channel.
212