Duplex; Flag Sdh - HP 6600 Command Reference Manual

Packets dropped by STP non-forwarding state: 321
Packets dropped by Rate-limit: 143
Packets dropped by broadcast-suppression: 301
Packets dropped by unicast-suppression: 215
Packets dropped by multicast-suppression: 241
Packets dropped by transmit egress aging: 246
For the description of some fields in the output, see

duplex

Use duplex to set the duplex mode for an Ethernet interface.
Use undo duplex to restore the default duplex mode of the Ethernet interface.
Syntax
duplex { auto | full | half }
undo duplex
Default
A 10-GE interface operates in full duplex mode, and all other types of Ethernet interfaces operate in auto
negotiation mode.
Views
Ethernet interface view
Default command level
2: System level
Parameters
auto: Sets the interface to operate in auto negotiation mode.
full: Sets the interface to operate in full duplex mode.
half: Sets the interface to operate in half-duplex mode. This keyword is not available for the fiber combo
ports and 10-GE interfaces.
Examples
# Configure interface GigabitEthernet 4/0/1 to operate in full duplex mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 4/0/1
[Sysname-GigabitEthernet4/0/1] duplex full

flag sdh

Use flag sdh to set a value for the overhead byte J0 or J1 in SDH frames when the 10-GE interface is
operating in WAN mode.
Use undo flag sdh to restore the default value of the J0 or J1 byte.
Syntax
flag { j0 | j1 } sdh value
undo flag { j0 | j1 } sdh
Table 9.
20