HP 6600 Command Reference Manual page 21

Field
link duplex type is autonegotiation
The Maximum Frame Length
Broadcast MAX-ratio
Unicast MAX-ratio
Multicast MAX-ratio
Allow jumbo frame to pass
PVID
Mdi type
Port link-type
Tagged VLAN ID
Untagged VLAN ID
Last clearing of counters: Never
Peak value of input
Peak time of input
Peak value of output
Peak time of output
Last 300 seconds input: 0
packets/sec 0 bytes/sec
Last 300 seconds output: 0
packets/sec 0 bytes/sec
Input (total): 21322 packets,
1748554 bytes
- unicasts, - broadcasts, -
multicasts, - pauses
Input (normal): 21322 packets, -
bytes
1268 unicasts, 7560
broadcasts, 12494 multicasts, 0
pauses
input errors
runts
Description
The interface will negotiate a duplex mode with its peer.
Maximum Ethernet frame length allowed on the interface.
Broadcast suppression threshold as a percentage of the maximum
interface rate. When the threshold is exceeded, the interface drops
broadcast packets.
Unknown unicast suppression threshold as a percentage of the
maximum interface rate. When the threshold is exceeded, the
interface drops unknown unicast packets.
Multicast suppression threshold as a percentage of the maximum
interface rate. When the threshold is exceeded, the interface drops
multicast packets.
Jumbo frames are allowed to pass through the interface.
Port VLAN ID.
Cable type.
Link type of the interface: access, trunk, or hybrid.
VLANs for which the interface sends packets without removing VLAN
tags.
VLANs for which the interface sends packets after removing VLAN
tags.
Time when the reset counters interface command was last used to clear
statistics on the interface. Never indicates that the reset counters
interface command was never used since the device was started.
Peak value of inbound traffic, in Bps.
Time of peak inbound traffic.
Peak value of outbound traffic, in Bps.
Time of peak outbound traffic.
Average rate of input and output traffic in the last 300 seconds, in pps
and Bps.
The statistics polling interval, 300 seconds in this example, can be
configured by using the flow-interval command.
Inbound traffic statistics (in packets and bytes) for the interface. All
inbound normal and abnormal packets (including unicast, broadcast,
and multicast), and pause frames were counted.
Inbound normal traffic (including unicast, broadcast, and multicast)
and pause frame statistics (in packets and bytes) for the interface.
Inbound packets with errors.
Inbound frames that are shorter than 64 bytes, that are in correct
format, and that contain valid CRCs.
12