E1 Channel-Set - HP 6600 Command Reference Manual

Syntax
display controller cpos cpos-number t3 t3-number [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
cpos-number: CPOS interface number.
t3-number: Number of a T3 channel on the specified CPOS interface, in the range of 1 to 3.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
Compared with the display controller cpos command, this command can display the error and alarm
information of lower-order paths and E3 frames. For possible error and alarm types, see
Examples
# Display the state information of T3 channel 1 on interface CPOS 2/0/0. For information about the
output fields, see
<Sysname> display controller cpos 2/0/0 t3 1
Cpos2/0/0 current state: UP
Description : Cpos2/0/0 Interface
T3 1 is down
Frame-format:
Alarm:
Error:

e1 channel-set

Use e1 channel-set to bundle timeslots on an E1 channel into one channel set.
Use undo e1 channel-set to remove the channel set (also mentioned as a bundle throughout this
document).
Syntax
e1 e1-number channel-set set-number timeslot-list range
undo e1 e1-number channel-set set-number
Default
An E1 channel is not channelized.
Table 28.
C-bit ,Clock: slave ,Loopback: none
NONE
0 FERR, 0 LCV, 0 PERR, 0 FEBE, 0 PARITY_P, 0 HCS
216
Table 27.