Storm-Constrain Enable Trap; Storm-Constrain Interval - HP 6600 Command Reference Manual

Default
A storm control-enabled port sends log messages when monitored traffic exceeds its upper threshold or
falls below its lower threshold from the upper threshold.
Views
Layer 2 Ethernet interface view
Default command level
2: System level
Examples
# Disable GigabitEthernet 4/0/1 from sending out log messages upon detecting storm control threshold
events.
<Sysname> system-view
[Sysname] interface gigabitethernet 4/0/1
[Sysname-GigabitEthernet4/0/1] undo storm-constrain enable log

storm-constrain enable trap

Use storm-constrain enable trap to enable an Ethernet interface to send storm control threshold event
traps. Triggering events include traffic exceeding the upper threshold and traffic falling below the lower
threshold from the upper threshold.
Use undo storm-constrain enable trap to disable trap message sending.
Syntax
storm-constrain enable trap
undo storm-constrain enable trap
Default
A storm control-enabled interface sends out traps when monitored traffic exceeds its upper threshold or
falls below its lower threshold from the upper threshold.
Views
Layer 2 Ethernet interface view
Default command level
2: System level
Examples
# Disable GigabitEthernet 4/0/1 from sending out storm control threshold event traps.
<Sysname> system-view
[Sysname] interface gigabitethernet 4/0/1
[Sysname-GigabitEthernet4/0/1] undo storm-constrain enable trap

storm-constrain interval

Use storm-constrain interval to set the traffic polling interval of the storm control module.
Use undo storm-constrain interval to restore the default.
48