Code (Ct1 Interface); Controller T1 - HP 6600 Command Reference Manual

code (CT1 interface)

Use code to set the line code format for a CT1 interface.
Use undo code to restore the default.
Syntax
code { ami | b8zs }
undo code
Default
The line code format for a CT1 interface is B8ZS.
Views
CT1 interface view
Default command level
2: System level
Parameters
ami: Adopts AMI line code format.
b8zs: Adopts bipolar 8-zero substitution (B8ZS) line code format.
Usage guidelines
Keep the line code format of the interface in consistency with the one used on the remote device.
To ensure the normal operation of the interface, configure the data-coding inverted command on it when
its line code format is set to AMI.
Examples
# Set the line code format of the interface T1 2/0/0 to AMI.
<Sysname> system-view
[Sysname] controller t1 2/0/0
[Sysname-T1 2/0/0] code ami
Related commands
data-coding

controller t1

Use controller t1 to enter CT1 interface view.
Syntax
controller t1 number
Views
System view
Default command level
2: System level
106