Display Controller Cpos - HP 6600 Command Reference Manual

slash (\), colon (:), semi-colon (;) quotation marks ("), apostrophe ('), comma (,), dot (.), and slash (/),
spaces, and other Unicode characters and symbols.
Examples
# Set the description for CPOS interface CPOS 3/1/1 to CPOS-interface.
<Sysname> system-view
[Sysname] controller cpos 3/1/1
[Sysname-Cpos3/1/1] description cpos-interface

display controller cpos

Use display controller cpos to display information about the state information of the specified CPOS
physical interface or all CPOS physical interfaces if no CPOS interface number is specified. The
command also displays alarms and errors that occurred to the regenerator section, multiplex section, and
higher-order path.
Syntax
display controller cpos [ cpos-number ] [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
cpos-number: CPOS interface number. If no CPOS number is specified, this command displays the
information about all CPOS interfaces.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
Table 24 Possible error types displayed in the output
Field
FRED
COFA
SEF
FERR
CERR
FEBE
Description
Receive loss of basic frame alignment, or receive frames with red alarm errors.
Change of frame alignment.
Severely error frame. Four consecutive frame synchronization errors generate one
SEF.
Framing Bit Error. It refers to frames with the Ft/Fs/FPS/FAS error.
CRC error.
Far end block error. This occurs when the CRC4 framing format applies on the E1
channel.
208