HP 6600 Command Reference Manual page 142

0 Line Code Violations, 0 Path Code Violations
0 Ais Alarm Secs, 2087 Los Alarm Secs
52 Slip Secs, 2087 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 2087 Unavail Secs
Table 20 Command output
Field
Serial2/0/0
Basic Configuration
Input
Output
Work mode
Cable type
Frame-format
fdl
Line code
Source Clock
Data-coding
Idle code
Itf type
Itf number
Loop back
Alarm State
Receiver alarm state
Transmitter is sending remote alarm.
Pulse density violation detected
SendLoopCode History:
inband-llb-up:0 times, inband-llb-down:0
times.
fdl-ansi-llb-up:0 times, fdl-ansi-llb-down:0 times.
fdl-ansi-plb-up:0 times, fdl-ansi-plb-down:0 times
BERT state:(stopped, not completed)
Test pattern: 2^15, Status: Not Sync, Sync Detected:
0
Time: 0 minute(s), Time past: 0 minute(s)
Description
Interface type and number.
Basic configurations for the interface.
Statistics about the input and output.
T1 interface operating mode, T1 framed in this sample
output.
Cable type of the interface, 100 ohm balanced in this
sample output.
Frame format configured on the interface: ESF or SF.
FDL format: ANSI, ATT, or none.
AMI or B8ZS.
Source clock used by the interface: master for the
internal clock or slave for the line clock.
Normal or inverted.
Idle code, 0x7E or 0xFF.
Type of inter-frame filling tags: 0x7E or 0xFF.
Number of inter-frame filling tags.
Loopback setting on the interface: local, payload,
remote, or not set.
Alarm state.
Type of received alarm: none, LOS, LOF, RAI, or AIS.
Type of transmitted alarm: RAI, or none.
The detected pulse density is incompliant with the
specification.
History of loopback code sending to the far-end,
including the number of transmissions for each type of
code, and the type of the last sent code. (For more
information, see
BERT state: completed, stopped (administratively
stopped), or running.
Test pattern in use, 2^15 in this sample output;
synchronization state, and the number of detected
synchronizations.
Duration of the BERT test and time that has elapsed.
133
"ft1 sendloopcode.")