Cpos Interface Configuration Commands; Bandwidth; Clock - HP 6600 Command Reference Manual

CPOS interface configuration commands

E1-related commands are available for CPOS (E) interface modules, and T1-related commands are
available for CPOS (T) interface modules.

bandwidth

Use bandwidth to set the intended bandwidth for the CPOS interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
CPOS interface view
Default command level
2: System level
Parameters
bandwidth-value: Intended bandwidth for the CPOS interface, in the range of 1 to 4,294,967,295 kbps.
Usage guidelines
You can obtain the intended bandwidth of an interface by querying the ifspeed value of the MIB node
with third-party software.
The intended bandwidth is used for bandwidth monitoring of the network management, but does not
affect the actual bandwidth of the interface.
Examples
# Set the intended bandwidth to 1000 kbps for interface CPOS 3/1/1.
<Sysname> system-view
[Sysname] controller cpos 3/1/1
[Sysname-Cpos3/1/1] bandwidth 1000

clock

Use clock to set the clock mode of the CPOS interface.
Use undo clock to restore the default.
Syntax
clock { master | slave }
undo clock
Default
The clock mode of a CPOS interface is slave.
205