HP 6600 Command Reference Manual page 200

Examples
# Display detailed information about interface POS 2/1/0.
<Sysname> display interface pos 2/1/0
Pos2/1/0 current state: DOWN
Line protocol current state: DOWN
Description: Pos2/1/0 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 5.5.5.2/24 Primary
Link layer protocol is PPP
LCP initial
Physical layer is non-channelized STM-4/OC-12
Frame-format is SONET, Current baudrate is 622080000 bps
Scramble enabled, crc 32, clock slave, loopback not set
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
SONET alarm:
section layer:
line
path
C2(Rx): 0xff
Rx: J0: unknown
Tx: J0: ""
Rx: J1: unknown
Tx: J1: ""
SONET error:
section layer:
line
path
Last clearing of counters: Never
Last 300 seconds input rate 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 no buffers
Output:0 packets, 0 bytes
# Display brief information about interface POS 2/1/0.
<Sysname> display interface pos 2/1/0 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Pos2/1/0
# Display brief information about all POS interfaces in the DOWN state.
<Sysname> display interface pos brief down
The brief information of interface(s) under route mode:
OOF LOF
layer: AIS
layer: AIS RDI
C2(Tx): 0x16
B1 65535
layer: B2 0
layer: B3 0
0 errors, 0 runts, 0 giants, 0 CRC
0 overruns, 0 aborts
0 errors, 0 underruns, 0 aborts
Link Protocol Main IP
UP UP
LOS
M1 0
G1 0
5.5.5.2
191
0/100/0
0/500/0
0/75/0
Description