Idle-Mark - HP 6600 Command Reference Manual

Field
Link: ADM - administratively down; Stby -
standby
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
Cause

idle-mark

Use idle-mark to set the line idle code of the synchronous serial interface to 0xFF.
Use undo idle-mark to restore the default.
Syntax
idle-mark
undo idle-mark
Default
The line idle code of a synchronous serial interface is 0x7E.
Views
Synchronous serial interface view
Default command level
2: System level
Description
Link status:
•
ADM—The interface has been administratively shut down.
To recover its physical state, perform the undo shutdown
command.
•
Stby—The interface is operating as a backup interface. To
see the primary interface, use the display standby state
command in High Availability Command Reference.
If the network layer protocol state of an interface is shown as
UP, but its link is an on-demand link or not present at all, its
protocol attribute includes the spoofing flag (an s in
parentheses).
Abbreviated interface name.
Physical link state of the interface:
•
UP—The link is up.
•
ADM—The link has been administratively shut down. To
recover its physical state, perform the undo shutdown
command.
Protocol connection state of the interface: UP, DOWN, or
UP(s).
Main IP address of the interface.
Description of the interface.
Cause of a DOWN physical link. If the port has been shut
down with the shutdown command, this field displays
Administratively. To restore the physical state of the interface,
use the undo shutdown command.
80