T3 Set Frame-Format - HP 6600 Command Reference Manual

Examples
# Enable FEAC signal detection on T3 channel 1 of interface CPOS 2/0/0.
<Sysname> system-view
[Sysname] controller cpos 2/0/0
[Sysname-Cpos2/0/0] t3 1 set feac detect
# Enable T3 channel 1 of CPOS 2/0/0 to generate and send DS3 LOS alarm signals.
<Sysname> system-view
[Sysname] controller cpos 2/0/0
[Sysname-Cpos2/0/0] t3 1 set feac generate ds3-los
# Enable T3 channel 1 of interface CPOS 2/0/0 to send loopback code to the far end to place the
far-end in a line loopback.
<Sysname> system-view
[Sysname] controller cpos 2/0/0
[Sysname-Cpos2/0/0] t3 1 set feac generate loopback ds3-line

t3 set frame-format

Use t3 set frame-format to specify a framing format for the specified T3 interface on the current CPOS
interface.
Use undo t3 set frame-format to restore the default.
Syntax
t3 t3-number set frame-format { c-bit | m23 }
undo t3 t3-number set frame-format
Default
C-bit framing is adopted on a T3 interface.
Views
CPOS interface view
Default command level
2: System level
Parameters
t3-number: Number of a T3 channel on the current CPOS interface, in the range of 1 to 3.
c-bit: Specifies C-bit framing (G.704) for carrying maintainable information such as FEAC.
m23: Specifies M23 (G.752) framing.
Examples
# Configure M23 framing on T3 channel 1 on interface CPOS 2/0/0.
<Sysname> system-view
[Sysname] controller cpos 2/0/0
[Sysname-Cpos2/0/0] t3 1 set frame-format m23
Related commands
t3 set feac
244