Lldp Check-Change-Interval; Lldp Compliance Admin-Status Cdp - HP 830 Command Reference Manual

rx: Specifies the Rx mode. A port in this mode only receives LLDP frames.
tx: Specifies the Tx mode. A port in this mode only sends LLDP frames.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDP frames.
Examples
# Configure the LLDP operating mode as Rx for Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp admin-status rx

lldp check-change-interval

Use lldp check-change-interval to enable LLDP polling and to set the polling interval.
Use undo lldp check-change-interval to restore the default.
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
Default
LLDP polling is disabled.
Views
Layer 2 Ethernet interface view, port group view
Default command level
2: System level
Parameters
interval: Sets the LLDP polling interval, ranging from 1 to 30 seconds.
Examples
# Enable LLDP polling on Ten-GigabitEthernet 1/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] lldp check-change-interval 30

lldp compliance admin-status cdp

Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP on a
port or all ports in a port group.
Use undo lldp compliance admin-status cdp to restore the default.
Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
Default
CDP-compatible LLDP operates in disable mode.
116