Lldp Compliance Admin-Status Cdp - HP 6125G Command Reference Manual

View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
interval: Sets the LLDP polling interval, ranging from 1 to 30 seconds.
Description
Use lldp check-change-interval to enable LLDP polling and set the polling interval.
Use undo lldp check-change-interval to restore the default.
By default, LLDP polling is disabled.
Examples
# Enable LLDP polling on GigabitEthernet 1/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lldp check-change-interval 30

lldp compliance admin-status cdp

Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
disable: Specifies the disable mode, where CDP-compatible LLDP cannot receive or transmit CDP
packets.
txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets.
Description
Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP on a
port.
Use undo lldp compliance admin-status cdp to restore the default.
By default, CDP-compatible LLDP operates in disable mode.
For your device to work with Cisco IP phones, you must enable CDP-compatible LLDP globally and then
configure CDP-compatible LLDP to operate in TxRx mode on the specified ports.
Related commands: lldp compliance cdp.
Examples
# Configure CDP-compatible LLDP to operate in TxRx mode on GigabitEthernet 1/0/1.
216