Lldp Compliance Admin-Status Cdp - HP 6125XLG Command Reference Manual

Use undo lldp check-change-interval to disable LLDP polling.
Syntax
lldp check-change-interval interval
undo lldp check-change-interval
Default
LLDP polling is disabled.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
interval: Sets the LLDP polling interval in the range of 1 to 30 seconds.
Examples
# Enable LLDP polling on FortyGigE 1/1/1 and set the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface fortygige 1/1/1
[Sysname-FortyGigE1/1/1] lldp check-change-interval 30

lldp compliance admin-status cdp

Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP.
Use undo lldp compliance admin-status cdp to restore the default.
Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
Default
CDP-compatible LLDP operates in disable mode.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
disable: Specifies the disable mode, where CDP-compatible LLDP cannot receive or transmit CDP
packets.
txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets.
Usage guidelines
You must enable CDP-compatible LLDP globally and then configure CDP-compatible LLDP to operate in
TxRx mode on the specified ports.
192