Switch And Port Leds - HP E3800-24G-2SFP+ Installation And Getting Started Manual

Introducing the E3800 Switches
Fronts of the Switches
Switch LEDs State
Power On
(green)
Off
Fault Off
(orange)
Blink
orange*
On
Locator On
(blue)
Blinking
Off
1-8
Out-of-Band Management (OOBM) Port
This RJ-45 port is used to connect a dedicated management network to the
switch.
Auxiliary (Aux) Port
An auxiliary port for processing a USB command file or downloading switch
software code. This port uses a USB Type A connector, but does not comply
with USB protocols and standards.

Switch and Port LEDs

Table 1-3 describes the switch and port LEDs and their operation for
■
standalone E3800 switches.
Table 1-4 describes the operation of the LEDs when the switches are
■
stacked. It includes descriptions of all stacking-related LEDs including
those for Module Status and Stacking Status.
Table 1-3. Standalone Switch and Port LED Behavior
Meaning
The switch is receiving power.
The switch is NOT receiving power.
The normal state; indicates there are no fault conditions on the switch.
A fault has occurred on the switch, one of the switch ports, module in the rear of the
switch, or the fan. The Status LED for the component with the fault will blink
simultaneously.
On briefly after the switch is powered on or reset, at the beginning of switch self test.
If this LED is on for a prolonged time, the switch has encountered a fatal hardware
failure, or has failed its self test. See chapter 4, "Troubleshooting" for more information.
The Locator LED is used to help you identify a specific in your network equipment
installation. The LED can be set to be on solid or to blink, and for a specified number of
minutes (1-1440). The default is 30 minutes. Use the command "chassislocate" to
control this LED.