Connecting The Co2 Measuring Hose - Weinmann MEDUMAT Standard2 Instructions For Use Manual

4. With the reusable hose system: Guide the connection line with
5. If necessary: Activate flow measurement + ASB option
6. If necessary: On connecting one of the two connection lines to
Result The FlowCheck sensor is connected to the device and is ready for
use.
4.4.5 Connecting the CO
Material damage due to lack of a water filter!
If CO
dirt and become damaged.
 Always use a water filter for CO
Requirement •
•
measuring hose system and ventilation hose into the hose
protection sleeve of the patient hose system.
"6.3.9 Options", page 134).
the device, perform a function check
function check", page 184)
software.
is measured without a water filter, the device can suck in
2
The ventilation hose is connected to the device.
The measuring hose system connector is connected to the
device.
4 Preparation and operation
(see "9.3 Performing a
to update the connection line
measuring hose
2
measurement.
2
MEDUMAT Standard
(see
2
EN 57