Set Up Of Equipment; Setting Up And Connecting The Cpap 20E - Weinmann Homecare CPAP 20e Manual

3. Set up of equipment

3.1 Setting up and connecting the CPAP 20e

1. Set up the unit on a flat surface, e.g. a bedside cabinet or on the floor next to the bed.
Caution!
Do not cover the unit or power supply. Do not use in the vicinity of a heater or in direct
sunlight. The unit may overheat, resulting in insufficient therapy delivery and damage to
the unit.
2. Plug the power supply cable into the supply connection of the CPAP 20e. Then plug the
power supply into a socket outlet (using the power supply cable).
DC adapter
16 Set up of equipment
The power supply automatically determines the appro-
priate mains voltage (115 V - 230 V).
Power
supply
If the CPAP 20e is to be operated with a voltage of
12 or 24 V DC, connect the WM 24469 DC adapter
(available as an option) instead of the power supply.
On the display „0" appears to show it is ready for use.
3. Plug the breathing hose into the unit outlet.
Note:
The device automatically compensates for differences
in air pressure (e.g. as a result of great altitude).