Oracle EXADATA X6-2 Installation And Configuration Manual page 228

Enter the destination prefix and mask, and other values as prompted.
13.
Destination prefix : 10.100.100.0
Destination prefix mask : 255.255.255.0
Next hop IPv4 address : 10.100.100.1
Skip configuring the DNS IPv4 addresses (this will be configured later).
14.
Configure the DNS IPv4 address? (yes/no) [n]: no
Skip configuring the default domain name (this will be configured later).
15.
Configure the default domain name? (yes/no) [n]: no
Accept the default responses until asked to configure SSH and the NTP server.
16.
Enable the telnet service? (yes/no) [n]: no
Enable the ssh service? (yes/no) [y]: yes
Type of ssh key you would like to generate (dsa/rsa) [rsa]: rsa
Number of rsa key bits <1024-2048> [1024]: 1024
Configure the ntp server? (yes/no) [n]: yes
NTP server IPv4 address : 10.100.100.3
Accept the default responses until asked to specify the CoPP system profile. Enter
17.
.
lenient
Configure default interface layer (L3/L2) [L2]:
Configure default switchport interface state (shut/noshut) [noshut]:
Configure CoPP system profile (strict/moderate/lenient/dense) [strict]: lenient
After reviewing the configuration, save the configuration.
18.
The following configuration will be applied:
no password strength-check
switchname test123sw-adm0
...
Would you like to edit the configuration? (yes/no) [n]:
Use this configuration and save it? (yes/no) [y]: yes
[########################################] 100%
Copy complete.
Add the VLAN 1 IP address.
19.
test123sw-adm0(config)# feature interface-vlan
test123sw-adm0(config)# interface vlan 1
test123sw-adm0(config-if)# ip address 10.100.100.110/24
test123sw-adm0(config-if)# no shutdown
test123sw-adm0(config-if)# exit
Set the spanning tree port type for ports 1-47.
20.
test123sw-adm0(config)# interface E1/1-47
test123sw-adm0(config-if)# spanning-tree port type edge
test123sw-adm0(config-if)# exit
Set on all 48 ports and set port 48 to a network port (instead of a host
21.
switchport
port).
test123sw-adm0(config)# interface E1/1-48
test123sw-adm0(config-if)# switchport
Chapter 5
Configuring the Cisco Ethernet Switch
5-16