Brake Pedal Height; Parking Brake - Honda MUV700 big red Service Manual

BRAKE PEDAL HEIGHT
Check the brake pedal for deformation or damage .
Check the brake pedal for smooth operation by
operating it several times.
Measure the brake pedal height from the accelera -
tor pedal.
STANDARD PEDAL HEIGHT: 25 - 40 mm (1 - 1-3/5 i n )
Adjust the pedal height as follows.
Remove the lock plate bolt (T50) and lock plate.
loosen the lock nut and turn the adjusting bolt (T50 )
as required. Temporarily tighten the lock nut while
holding the adjusting nut.
The
pedal freep/ay
Make sure the brake pedal freeplay at the end of the
IS
from the
pedal is within 1 - 5
Mm .
looseness at rhe
If the freeplay is not within standard value, loosen
pedal Pivot WI/houl
the lock nut and turn the adjusting bolt until the
preSSing the master
freeplay is within 1 - 5 mm.
cylmder lad
Recheck the pedal height after adjusting the pedal
freeplay.
After adjustment procedure is completed, tighten
the lock nut to the specified torque while holding
the adjusting bolt.
TORQUE : 22 N ·m 12.2 kgf·m , 1S lbf.ft)
Install the lock plate agai nst the lock nut and tighten
the plate bolt.
TORQUE : 22 N ·m (2.2 kgf.m , 1Slbf·ft )
Check for brake l ight operation (page
4-19).
PARKING BRAKE
Pull the parking brake lever and check the freeplay
at the lever end.
LEVER FREEPLAY: S5 - 85 mm 12.S - 3.3 in )
If the parking brake lever freeplay is out of specifica-
tion, adjust the parking brake as follows.
MAINTENANCE
4-21