Honda MUV700 big red Service Manual page 291

SUB-TRANSMISSION/ GEARSHIFT LINKAGE
INSTALLATION
Apply locking agent to the pivot bolt threads.
Install the spring, washer (between the crankcase
and arm) and stopper arm w ith the bolt as shown
and tighten the bolt
TORQUE: 12 N'm (1,2 kgf·m, 9 Ibf.ft)
Install the snap ring into the spindle groove with the
chamfered edge facing the crankcase cover side
Install the shifter gear with the inde)( line facing the
snap ring, aligning the wide groove with the wide
tooth.
Install the gearshift spindle and rest it onto the stop·
per on the crankcase.
Install the washer onto the spindle.
Apply engine oil to the shift drum guide groove.
Lift the stopper arm and install the shift drum so the
index line on the spindle shifter gear is aligned
between the punch marks.
Turn the shift drum clockwise and set it in neutral
position so its groove position is lengthwise.
Apply engine oil to the lips of a new oil seal, and
install it into the front crankcase covet until fully
sealed.
12-13