Drive Mode Selector Lever Linkage Installation - Honda MUV700 big red Service Manual

INSTALLATION
Apply grease to the selector lever arm pivot.
Connect lever arm to the 2WO/4WD selector cable
and install the lever arm onto the frame with the
pivot bolt (washer-bolt).
Connect the rear differential lock cable to the lever
arm and secure it with the washer and a new coner
pin.
Tighten the pivot bolt.
Apply grease to the groove in the selector lever
pivot bolt.
Install the lever spring onto the selector lever in the
direction as shown.
Install the selector lever through the lever gale and
onto the lever arm by setting the lower spring end
into the arm groove. Hold the lever pivot securely to
align the bolt holes, then install the pivot bolt
(socket bolt).
Install the pivot nut and tighten it.
TORQUE: 26 N 'm (2.7 kgf·m , 20 Ibf.ft)
Connect the front differential lock cable to the selec-
tor lever from the lower side. Install the joint nut
and tighten
it.
FRONT DRIVING MECHANISM
19-43