Ignition Coil Removal/Installation - Honda MUV700 big red Service Manual

Turn the ignition switch to OFF (0 ).
Remove the engine front cover (page 3·6).
Remove the alternator 5P black connector from the
st ay and disconnect it.
Connect the peak vol t age tester or adaptor probes
to the alternato r side connector terminals.
CONNECTION: Blue/ yellow 1+) - Green / white H
In the same manner as at the peM connector,
measu re the peak vo ltage and compare
it
to the
voltage measu red at the pe M
connector.
• If the peak vol t age measured at the peM
connector is abnormal and the one measured at
the alternato r connector is normal, the Blue/
yellow or Greenlwhite wire has an open or short
circuit, or loose connection.
• If both peak voltages are abnormal , follow the
checks described in the troubleshooting chart
(page 22-4).
If the CKP sensor is faulty, replace the stator/CKP
sensor assembly (page 11-7).
IGNITION COIL
REMOVAL/INSTALLATION
Remove the seat center cover (page 3-5).
Disconnect the plug ca p from the plug.
Remove the two ignition coil mounting bolts.
Disconnect the primary wire connectors and
remove the ignition coil.
Installation is i n the reverse order of removal.
IGNITION SYSTEM
5P BLACK CONNECTOR
22-7