Front Wheel/Suspension Service Information; Front Wheel/Suspension Specifications; Front Wheel/Suspension Torque Values - Honda MUV700 big red Service Manual

SERVICE INFORMATION
GENERAL
FRONT WHEEL/SUSPENSION
• A contaminated brake disc or pad reduces stopping power. Discard contaminated pads and clean a contaminated disc
with
a
high quality brake degreasing agent.
• A jack or other support is required to support the vehicle (page 1-48),
• Do not twist or bend the brake hose and pipe when serving.
• Use Honda Genuine replacement bolts and nuts for all suspension pivots and mounting points.
• Adjust toe whenever the knuckle or steering gear box components are replaced or removed (page 4-27).
• For brake system service, see Brake System section (page 18-2!.
• For steering system service, see Steering System section (page 16-2).
SPECIFICATIONS
ITEM _ _
----' S T'.!,AN DARD
SERVICE LIMIT
Minimum tire tread depth _ _ --+--" 4 mm (0.2 in)
Cold lire pressure
1
~js~taa~n~d~a!' ~ d~======j7~oi k~ p !a:tlo[.~7£O~k~9~ f/~cm?',~'~Ot'05:fP~Stt;I==_=t=~====j
I
With ca rgo 70 kPa (0.70 kgflcm • 10.0 psi)
TORQUE VALUES
Wheel nut
Wheel hub nut
Brake disc bolt
Brake disc splash guard socket bolt
Drive shaft outboard guard (at caliper)
Drive shaft guard bolt (at lower arm)
Shock absorber mounting nut
Brake hose damp bolt
Upper and lower arm pivot nut
Upper and lower arm ball joint nut
Tie-rod joint nut
Front brake caliper mounting bolt
108 N 'm ('1.0 kgf·m. 80 Ibf.fl)
137 N'm (14.0 kgf.m, 101 Ibf·ft)
42 N'm (4.3 kgf·m, 31 Ibf.ft)
11 N·m 0.' kgf·m, 8Ibf·ft)
l' N'm (1.1 kgf·m, 8Ibf·ft)
11 N'm (T.l kgf·m, 8Ibf·ft)
44 N'm (4.5 kgf·m, 33 Ibf·ft)
12 N'm (1.2 kgf·m,9Ibf.ft )
64 N'm (6.5 kgf·m, 47 Ibf·ft)
49 N'm (5.0 kgf·m, 36 Ibf·ft)
49 N'm (5.0 kgf·m. 36 Ibf·ft)
108 N'm (11.0 kgf·m, 80 Ibf·ft)
Castle nut: tighten to the specified t orque and
further tighten until its grooves aligns with the
cotter pin hole.
ALOe bolt: replace with a new one.
ALoe bolt: replace with a new one.
ALoe bolt: replace with a new one.
ALOe bolt: replace with a new one.
Lock nut: replace with a new one.
ALOe bolt: repla ce with a new one.
Lock nut: replace with a new one.
Castle nut: tighten to the specified torque and
further tighten until its grooves aligns with the
cotter pin hole.
Castle nut: tighten t o the specified torque and
further tighten until its grooves aligns with the
cotter pin hole.
ALoe bolt: replace with a new one.
15-3