Front Wheel Hub And Knuckle Installation - Honda MUV700 big red Service Manual

FRONT WHEEL/SUSPENSION
Set the knuckle and special t ools with "An mark side
of the removerlinstaller facing to the ball joint in the
vise as shown.
Press the bait joint into the knuckle until
it
is fully
seated.
TOOLS:
Ball joint remover/ installer
Ball joint base
I
NOTICE
07JMF·HC50110
07JMF·HC50120
or
07746-0020400
If
you
feel strong resistance when compressing the
vise, stop. Reset the remover/installer of the tool
so
that the ball joint
can
go into the remover/installer
and try again.
Install the snap ring with the chamfered edge facing
in .
INSTALLATION
Install rhe mner seal
Coat the tips of new inner and outer dust seals with
first, then install the
grease and install each dust seal u ntil it is flush with
ourer
seal.
the knUCkle, being careful not to damage the lip.
15-14
TOOLS:
Driver
Oil seal driver attachment
Driver attachment
07749·0010000
07947·6340201
or
07AMD·Hl1A100
(U .S.A. onIV)
Pack the lip cavities of the inner dust seal with 2.5-
3 g of grease.
REM OVE R/INSTALLER