Quick Connect Fitting Installation - Honda MUV700 big red Service Manual

If
it is
hard /0
connect the fittmg,
put
8
small amoum
of engme
011
on the
fuel
pipe
end.
QUICK CONNECT FiniNG
INSTALLATION
NOTE
• Always replace the retainer and joint rubber of
the quick connect fitting when the fuel feed hose
is disconnected.
• Use the same manufacture's retainer as the
removed one.
• Do not bent or kink the fuel feed hose.
INJECTOR SIDE
1. Insert a new retainer into the connector.
2. Install a new joint rubber onto the fuel pipe.
3. Install the con nector on the fuel pipe straight and
align the retainer grooves with the joint rubber
tabs as shown.
Then press the connector onto the fuel pipe until
both locking pawls click.
4. Make sure that the quick connect fitling is con-
nected securely and the locking pawls afe locked
firmly by pulling the connector.
5. Install the hose clamp onto the feed hose and
throttle body by aligning the hole with the boss,
and tighten the screw.
FUEL SYSTEM (PGM·FI)
CONNECTOR
sit
RETAINER
CONNECTOR
\ ~
"' (
~
JOINT
S
RUBBER
LOCKING PAWLS
6-33