Honda MUV700 big red Service Manual page 532

REAR DRIVING MECHANISM
Install a new stopper ring i nto the groove in a new
bearing.
Make sure the
Install the bearing into the compressor u ntil the
stopper nng stays
bearing is flush with the end of the tool.
In the groove
20-28
TOOL:
Bearing clip compressor,
28mm
070ME-HN80200 or
070ME-HN8A200
(U.S.A . only)
Place the driv er and attachment o n the t op of the
bearing and tape the dr iver to the compressor.
TOOLS:
Driver
Attachment, 24 x 26 mm
Puller attachment
Pilot , 17 mm
07949-3710001
07746-0010700
01VMC-GCS0100
(not avai lable in
U.S.A.) or
07746-0040400
Place the bearing and tool assembly into a freezer
for at least 30 minutes.
Using a heat gu n, heat the gear case to 80°C (176°F).
Remove the bearing and tool assembly from the
freezer and drive the bearing into the gear case
using the special tools.
Only strike the driver once . If you strike it more than
once, the stopper ring may slip o ut of the groove.
If this happens, remove the ring and beari ng, and
install a new ring.
Make sure that the stopper ri ng is securely set in the
groove of the gear case.
" . STOPPER RING
COMPR ESSOR