Rear Crankcase Cover Bearing Replacement - Honda MUV700 big red Service Manual

SUB-TRANSMISSION/GEARSHIFT LINKAGE
12-6
- bolt and ground cable
- two 8 mm bolts
- oit drain bolt, sealing washer and O-ring
- eleven 6 mm bolts
- rear crankcase cover
- two dowel pins
- oil joint collar and O-rings
- gasket
- oil seals (from the rear crankcase cover)
BEARING REPLACEMENT
Refer to Crankcase/Crankshaft/Balancer section for
rear crankcase beari ngs replacement (page 13-10).
OUTPUT SHAFT BEARING
Press the needle bearing out of the crankcase cover.
TOOLS:
Driver
Attachme nt. 28 x 30 mm
Pilot, 25 mm
07749-0010000
07946, '870100
01146-0040600
Press in a new bearing unlil it is seated.
TOOLS:
Driver
Attachment, 37 x 40 mm
Pilot, 25 mm
COUNTERSHAFT BEARING
07749·0010000
07746-0010200
07746-0040600
Remove the bearing using the special tools.
TOOLS:
Bearing remover, 17 mm
Remover handle
Remover wei9ht
07936·3710300
07936-3710100
07741· 0010201 or
07936-37102OA
(U .S.A . only) or
07936-3710200
(U.S.A. only)