Honda MUV700 big red Service Manual page 105

Apply approximately 20 9 (0.7 oz) of Pro Honda
Form Filter Oil or equivalent oil from the inside of
the element.
Place the element into a plastic bag and spread the
oil evenly by hand.
Install the element core into the air cleaner element,
aligning the locating pin with the hole.
Clean the inside of the air cleaner housing and
cover.
Make sure the rubber seal in the air cleaner cover is
in position and in good condition.
Install the element band onto the air cleaner ele-
ment and the element assembly over the connect-
ing tube flange of the housing securely.
Tighten the band screw.
NOTE :
• Failure to properly tighten the band screw will
allow the ai r cleaner element to fall off and
engine damage could result .
Install the air cleaner cover while aligning the
stepped area with the element as shown.
Secure the air cleaner housing cover with the retain-
ing clips and lid springs.
lower the ca rgo bed.
MAINTENANCE
PRO HONDA FOAM FIL TEA OIL
PLASTIC BAG
ELEMENT
4-7