Clutch Initial Clearance Check - Honda MUV700 big red Service Manual

Install the wave spring into the piston groove.
Coat the clutch discs with engine oil.
Inst all the three clutch plates and discs alternately,
starting with the plate.
Install the end plate with the stepped side facing
out.
Install the st opper ring into the drum grooves prop-
erly,
Check the clutch initial clearance (page 14-53).
CLUTCH INITIAL CLEARANCE CHECK
Set a dial indicator on the end plate with the plate
lowered .
lift
the end plate up against the stopper ri ng and
read the clearance. and record
it.
Perform this inspection at the three points in 120
Q
apart .
STANDARD: 0.7 - 0.9 mm (0.03 - 0.04 in )
If the clearance is not wi thin the st andard value,
select the replacement end plate as follows:
Remove t he stopper ring and end plate.
Measure the flange thickness of the end plate at
several points and record it.
Calculate the new plate thickness using the equa-
tion below. Choose a new plate as close to this
dimension as possible.
A = (8-0.8) + C
A: New plate thickness
8: Recorded clearance
C: Old plate thickness
DRIVETRAIN SYSTEM
CLUTCH PLATES
<T(lPPI FR RING
END
14-53