Front Crankcase Cover Inspection - Honda MUV700 big red Service Manual

DRIVETRAIN SYSTEM
14-38
- pipe setting collar !by pushing it from the inside
with
a
suitable rod) and O-rings
- oil feed pipe C and O-ring
- output shaft oil seal
- oil filter (page 4-14)
- dipstick
- sealing bolts and washers
- oil path bolt and O-ring
- three bolts, oil pipe joint and O-ring
Wash the crankcase cover with solvent and blow
through all the passages with compressed air to
clean them thoroughly.
INSPECTION
Check feed pipes A, Band C for abnormal wear or
damage.
NOTE .
• The operating (engine) oil of each shift clutch is
supplied through the following:
- feed pipe A for the 1st shift clutch
- feed pipe B for the 2nd shift clutch
- feed pipe C for the 3rd shift clutch
Check the crankshaft seal collar behind the bearing
for abnormal wear or damage.
NOTE -
• The crankshaft seal collar is for the engine oil
supplied to the torque converter and crankpin
Replacement (page 14-39),
OIL PIPE JOINT OIL PATH BOLT, O-RING
.,
~~)
•
'\
•
•
•
~,,'"
DIPSTICK
SEALING BDl.TS. WASHERS