Parking Brake Lever Bracket; Center Frame Cover - Honda MUV700 big red Service Manual

PARKING BRAKE LEVER BRACKET
Remove the engine front cover (page 3-6).
Secure the vehicle from rolling. release the
parki ng brake, and remove and/or
disconnect the following:
- throttle cable (from the cable clip)
- two hose dips (from
reverse side of the
bracket)
- brake switch wire clip
- brake switch 2P (black) connector
- adjusting nut and joint pin (to disconnect
the brake rod)
- rod sp ring
four socket bolts
- brake lever bracket
Installation is in the reverse order of
removal.
TORQUE:
Socket bolt: 38 N'm (3.9 kgf·m , 28 Ibf.ft)
After installation, adjust the pa rking brake
lever (page 4-21),
CENTER FRAME COVER
Unlock the cargo bed by pull
i ng up on the
release lever and then raise t he bed.
Remove the following fasteners:
- five trim clips
- four setting screws
(two 6
x
18 mm )
(two 6
x
20 mm)
Release the center frame cover from the seat
under cover carefully.
Disconnect the accessory socket 2P (g reen)
connector to remove t he frame cover.
Align the matmg
Installation is in the reverse order of removal.
area of the frame
cover and
sear
under cover
properly
FRAME/BODY PANELS/EXHAUST SYSTEM
SOCKET
BOLTS
NUT
SPRING
j
CONNECTOR
11
HOSE CLIPS
I I
I
6
x
20 mm
FRAME COVER
3-7