Honda MUV700 big red Service Manual page 286

SUB-TRANSMISSION/GEARSHIFT LINKAGE
Install a new sealing washer onto the drain bolt.
Coat a new O-ring with engine oil and install it into
the drain bolt groove.
Install the rear crankcase cover with the following
fasteners:
- eleven 6 mm bolts
- two
8
mm bolts
- oil drain bolt
Tighten the bolts in a crisscross pattern in several . .
-~!
steps.
TOROUE: Drain bolt: 25 N-m 12.5 kgf-m,
18
Ibf·ttl
Temporarily install the gear selecto r arm and make
sure the sub-transmission is into neutral (page 12-
17).
Coat a new O-ring with engine oil and install
it
into
the groove in the gear position switch.
Becarefulrlorro
Align the long end of the switch pin with the "N"
damage the SWitch
mark. Instal! the switch by aligning the switch pin
pm durmg
with the slot in the crankcase cover.
installation.
Install the bolts and tighten it.
12-8
Route the gear position switch wi re properly, secure
the wire with the clamp on the crankcase cover.
Install the ground cable with the bolt.