Fuel Line Inspection; Fuel Pressure Relieving; Quick Connect Fitting Removal - Honda MUV700 big red Service Manual

FUEL LINE INSPECTION
FUEL PRESSURE RELIEVING
1. Remove the passenger seat under cover (page 3-
61.
2.
Turn
the ignition switch to OFF (0).
3. Disconnect the fuel pump 5P connector.
4.
Start the engine, and let it idle unti l it stalls.
5. Turn the ignition switch to OFF (0).
QUICK CONNECT FITTING REMOVAL
NOTE
• Before disconnecting fuel feed hose, relieve pres-
sure from the system (page 6-31).
• Do not bent or twist fuel feed hose.
INJECTOR SIDE
1. Remove the center frame cover (page 3-7).
2. Clean the quick connect fitti ng if necessary, and
place a shop towel over the quick connect fitting.
3.
Remove the wire band from the clamp and
remove the screw and the hose clamp from the
throttle body and feed hose.
FUEL SYSTEM (PGM-FI)
4. Hold the connector with one hand, squeeze the
~1II1II1II~~~~~III~III~:g~~IIIIII~
retainer tabs with the other hand to release the RETAINER TABS
locking pawls from t he connector and pull the
connector off t he fuel pipe.
• Prevent the remaining fuel in the fuel feed hose
from flowing out with a shop towel.
• Be careful not to damage the feed hose, connec-
tor and fuel pipe.
• Do not use lools.
• If the connector does not move, keep the retainer
tabs pressed down, and alternately pull and push
the connector until it releases.
5. Remove the retainer and joint rubber from the
fuel pipe.
6. To prevent damage and keep foreign matter Qut,
cover the connector and fuel pipe with plastic
bags.
CONNECTOR
~\
LOCKING PAWLS
6-31