Rear Suspension Arm Inspection; Rear Suspension Arm Installation - Honda MUV700 big red Service Manual

INSPECTION
Check the pivot bushings for wear or damage.
For pivot bushing inspection of the knuckle side, see
Rear Wheel Hub/Knuckle (page 17-6),
Check the stabi l izer bushings for wear or damage.
Check the stabilizer arm fo r distortion or damage.
Inspect t he ball joint boots of the link for tears or
other damage by m oving the ball joint stud.
INSTALLATION
NOTE:
• The upper and lower arm pivot fastener tighten-
ing is performed after adjusting the suspension
arm angle (page 17-15).
STABILIZER ARM AND LINK
Install the stabilizer bushings and holders onto the
st abilizer arm.
Inst all the stabilizer arm onto the frame with new
bolts and the nuts. Tighten the four bolts while
holding the nuts alternately.
TORQUE: 27 N'm
(z.a
kgf·m , 20 Ibf.ft)
REAR WHEEl/SUSPENSION
BUSHINGS
BOOTS
BUSHING
LINK
17-13