Rear Final Drive Installation - Honda MUV700 big red Service Manual

REAR DRIVING MECHANISM
It
IS
Importam
fO
tum the pinion gear
while tlgh/enmg the
baits, If the flng
gear shim
IS
too
thIck, the gears will
lock after only light
/lgtJrenmg.
Install the proper ring gear shims onto the differen-
tial assembly.
Install the differential assembly into the gear case.
Coat a new O-ring with grease and install it into the
cover groove.
Install the case cover onto the gear case.
Apply locking agent to the threads of the two 10-
mm bolts.
Install the six bolts and tighten them in several
steps until the cover evenly touches the case. Then,
white rotating the pinion gear, tighten the bolts to
the specified t orque in a crisscross pattern in sev-
eral steps.
TORQUE: 10 mm bolt: 46.5 N 'm (4 .7 kgf·m , 34Ibf.ft)
8 mrn bolt: 25 N ·m (2.6 kgf·m , 19 Ibf.ft)
Make sure that the gear case assembly rotates
smoothly without binding.
Install the differential lock clutch housing (page 20-
19).
REAR FINAL DRIVE INSTALLATION
o
10 mm BOLTS
1Il!iI
Coat a new a-ring with molybdenum disulfide
r-::o:-- -=-
20-32
grease and install it int o the groove in the output
shaft.
Apply molybdenum disulfide grease to the splines
of the both sides in the universal joint.
Install the universal joint onto the output shaft until
it is fully seated.