Table 6-7 Corrective Actions For Missing Or Bad Base Radio Parameters - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Base Radio Receiver Configuration

Table 6-7 Corrective Actions for Missing or Bad Base Radio Parameters

Missing or Bad
Parameter
atten_default
dekey_limit
rx_dc_inj_usl
rx_dc_inj_lsl
ad1_scaling6
rx_fru_config
6-20
• For MTS 4, type set nvm_param rx1 atten_default 0
and press Enter.
• For MTS 2, type set nvm_param rx1 atten_default 4
and press Enter.
• If the parameter is missing for MTS 4, add it by typing set
nvm_miss_param rx1 atten_default 0 and press Enter.
• If the parameter is missing for MTS 2, add it by typing set
nvm_miss_param rx1 atten_default 4 and press Enter.
Type set nvm_param pa dekey_limit 6 and press Enter.
Type set nvm_param rx1 rx_dc_inj_usl 1.5 and press Enter.
Type set nvm_param rx1 rx_dc_inj_lsl 0 and press Enter.
Type set nvm_param rx1 ad1_scaling6 28.9 and press Enter.
Type set nvm_param rx1 rx_fru_config [X] where the values
for [X] are:
• 1 - Receiver branch 1 enabled
• 2 - Receiver branch 2 enabled
• 3 - Receiver branches 1 and 2 enabled
• 4 - Receiver branch 3 enabled
• 5 - Receiver branches 1 and 3 enabled
• 6 - Receiver branches 2 and 3 enabled
• 7 - Receiver branches 1, 2 and 3 enabled
Press Enter.
After the parameter(s) has been updated the following is needed for the
configuration changes to take effect:
Type reset , press Enter and then type y to verify the reset.
Chapter 6: Configuration and Testing
Corrective Action
6802800U74-N September 2009