Millipore Spectroquant Multy Operating Manual page 31

Start by pressing the [Enter] key.
The complete method list appears on the display.
Methods showing a dot (•) following the method number
appear in the method-selection list, while methods without
the dot are not shown.
Press the [] or [] keys to position the cursor next to the
method to be processed.
Use the [F2] key to switch between "activated" and "deactivated".
Deactivated methods are then shown without the dot.
Select the next method and follow the above procedure to
adjust the list to match your requirements until all methods
show the desired settings.
Confirm your selection for saving by pressing [Enter].
Pressing the [Esc] key
and then the [Enter] key
enables you to exit this mode at any time without adopting
the alterations.
Tip
In the event that you wish for only a few methods to be shown
in the method-selection list, it is advisable to first execute
mode 62 "Mlist all off" (deactivate all methods) and then to
process the method-selection list using mode 60 "Method list".
All you then need do is select the methods that you would
like to include in the method-selection list for later use by
marking them with the dot (•).
The names of the user polynomials (1-25) and user concentra-
tions (1-10) all appear in the method list, even when they are
not programmed. Unprogrammed methods cannot be activated!
<methods list>
>>10•Acid cap. 01758
20•Aluminium 14825
21•Aluminium 00594
...
<methods list>
>>10•Acid cap. 01758
20 Aluminium 14825
21•Aluminium 00594
...
en
33