Starting The Colorimeter The First Time; Overview Of The Mode Menu - Millipore Spectroquant Multy Operating Manual

1.4 Starting the colorimeter
the first time
en
1.5

Overview of the mode menu

Mode No. Mode function
10
11
12
13
14
20
21
22
12
Switch on the colorimeter by pressing the [On/Off] button.
The unit runs an electronic self-check test.
The display then shows:
Pressing the [Enter] key takes the colorimeter to method
selection.
Any data already saved in the unit must be deleted (mode 34,
see chapter 1.7, "Delete data"), the user-method system must
be initialized (mode 69, see section 5.6.5, "Initializing the
user-method system (concentration and polynomials)"), and
the date and time should be reset. (See below for details.)
The Spectroquant® Multy is supplied with English preset as the
standard language setting. Before making the first measurement
you should therefore reset the unit to the language of your
choice. To do this go from the method list and change to the
mode menu by pressing the [Mode] key.
The display shows:
After a short time the selection list appears:
Brief description
Language Setting the language
Key-beep Activating the acoustic key-acknowledgment tone
Clock Setting the date and time
Countdown Activating/deactivating the countdown for reaction times
Signal-beep Activating/deactivating the acoustic signal at the end of a measurement 3.3.2
Print Printing all saved measurement results
Print, date Printing measurement results from a defined date range
Print, code No. Printing measurement results from a defined code-No. range
Please initialize
the storagesystem
with MODE 34
MODE Menu
cancel: ESC
>> 10:Language
11:Key-beep
12:Clock
... ...
... ...
Section
1.6
3.3.1
1.8
3.3.3
5.3.2
5.3.3
5.3.4