Millipore Spectroquant Multy Operating Manual page 234

Selecting the COM interface
At "Connect using:" use the "Direct link using COM1",
"Direct link using COM2", etc. to select the COMx interface
with which the colorimeter data-transfer cable is connected.
Then click on "OK".
The display now shows:
Fig. 8
Setting the interface parameters
Now you must make the following settings:
Bits per second (baud rate):
Data bits:
Parity:
Stop bits:
Flow control:
The settings for the parameters "Flow control" and "Baud rate"
are now the same as those entered in the Spectroquant®
Multy.
19200
8
None
1
Xon / Xoff
Chapter 5.4 | Page 5 of 19