Millipore Spectroquant Multy Operating Manual page 238

This saves the set parameters in a "session file". Later on
HyperTerminal can be started by clicking on this file (see below
for further instructions) and subsequently automatically uses
the parameters that have already been set.
To receive data with the aim of saving them, you must now
select the menu "Data Transfer" and there click on the
submenu "Capture Text ...". As mentioned above, the colorimeter
should already be switched on and connected.
Fig. 14
Fig. 15
The following window appears:
Here you can set the file in which the data are to be saved.
In our following example we have left the basic settings the
way they originally were and have thus saved the data in the
file CAPTURE.TXT in the directory C:\Programmes\Tools\
HyperTerminal.
Click on "Start" and the programme is ready to receive data
and to save them. Attention: The data are saved only after the
data-transfer procedure is complete, as described below!
(See also "End data transfer and save data" on page 11).
On the colorimeter now activate one of the mode functions to
print saved data and proceed as described in section 5.3 of the
colorimeter manual.
Chapter 5.4 | Page 9 of 19