Millipore Spectroquant Multy Operating Manual page 228

5.3.4 Printing measurement results
from a defined code-No. range
In this mode all measurement results from a defined code-No.
range are printed out.
If you wish to print out only test results with the same code
No., enter the same code for both the start and end codes.
To print out all test results without the code No. or with the
code No. 0, enter zero (0) for both the start and end code Nos.
Press the keys [Mode] [2] [2] in succession.
Confirm your selection by pressing [Enter].
The display now shows:
Enter the start code number (max. 6 digits), e.g. [1] [0] [0].
Confirm by pressing the [Enter] key.
The display then shows:
Enter the end code number (max. 6 digits), e.g. [1] [3] [0].
Confirm by pressing the [Enter] key.
The display then shows:
Pressing the [Enter] key prints out the saved test results from
the defined code-No. range.
After the printout operation the colorimeter returns to the
mode menu.
< Print>
sorted: Code-No.
from ______
< Print>
sorted: Code-No.
from 100___
to ______
<Print>
sorted: Code-No.
from 000100
to 000130
Start:
cancel:ESC
Chapter 5.3 | Page 5 of 6