Millipore Spectroquant Multy Operating Manual page 230

5.4 Transferring data to a PC
The Spectroquant® Multy Colorimeter can transfer data to a PC
via the RS232 interface. The data is transferred by the
"Hyperterminal" software contained in the standard Windows
package.
The instructions given below describe the transfer of data
to the Windows® 98 HyperTerminal programme. It can be
considered equivalent also for other Windows versions
(3.11, WIN95, WIN NT, WIN XP etc.).
Users of the Windows version "Windows 7" must use the
Spectroquant® Data Transfer Software to transfer the data. This
software tool together with the corresponding instructions for
use can be downloaded from www.analytical-test-kits.com (see
Multy Colorimeter "Technical info").
Using HyperTerminal
Connect the Spectroquant® Multy and one of the free serial
interface ports of your computer using the cable supplied with
the package. Switch the colorimeter on and wait for the self-
check routine to end.
Press the colorimeter keys [Mode] [2] [9] in succession
and then the [Enter] key.
The display now shows:
Press the [1] key and use
the [] or [] arrow keys to select flow control Xon/Xoff.
Confirm by pressing [Enter].
Exit the menu by pressing [Esc].
Now press the [2] key to select the baud rate. Use the cursor
keys the select the baud rate 19200.
Confirm by pressing [Enter].
Exit the menu by pressing the [Esc] key twice.
Now exit the mode menu and return to the method-
selection mode.
< printing params.>
1:Flow control
2:Baud rate
Ende:ESC
Chapter 5.4 | Page 1 of 19